PistolToter

Specs say 1.00 to 1.169 so you're good to go.

My recent experience with range pick up brass tells me it may not be the bullets or the dies. I would mic everything from where your bulge is to the diameter of the brass you are trying to reload. With so many people shooting 9mm Major it's easy to pick up brass that is way out of spec. I had brass that when loaded would not plunk no matter how I tried to load it. I finally found the small percentage of cases that would not plunk measured .390 just ahead of the web. Check your cases that won't plunk to see if you have discovered the same problem.

I wish to thank everyone that has tried to help with the problem I posted earlier! I know why everything went south now. The last bunch of brass I picked up at the range was the problem all along. I had no idea anyone in my area was firing 9mm Major. Boy was I wrong the cases I picked up all measured .390 just ahead of the web. That diameter just will not work in the Kart barrel of my gun. Thanks again!

OAL is set at 1.045 6 of 20 failed plunk test. Using RMR MPR 124gr. HP. Have never used them before. OAL was set using my barrel and verniers. So I know they should plunk with no problem. Case length is running 7.44- 7.46

Loaded some 9s for a new bullet configuration using my lee dies. No problems at all when testing the new load. When I went into production on my Dillon 1050, 6 of 20 would not chamber in the Karl barrel. Absolutely no problem running through my Glock. Wondering what is going on! I guess I will have to order the U die to see if I can get a run to work.