JMoses
-
Posts
5 -
Joined
-
Last visited
JMoses's Achievements
Looks for Range (1/11)
-
Thanks, I will go tomorrow and grab a variety of shells to test out. Is there anything I should look for in the chamber it feels smooth and I see no rough spots.
-
Clarify this for us, is the case head separating from the hull or are you saying that the case and hull are only being partially extracted from the chamber (but still fully connected to each other)? The metal is seperating from the plastic hull. The shell only extracts enough that the bolt wont completly close. Other than that ive had no other issues.
-
I've had an issues lately with possible extraction issues but not sure. After I fire 12 then reload and fire again I usually get to the last or second to last round and the extractor fails to pull the round out, but the extractor has pulled the rim of the case partially from the hull. I have to punch out the hull which is pretty tight in the chamber. I'm firing federal bulk. Is it an extractor or ammo issue? I haven't tried any other ammo yet I have thousands of federal so thats what I've been using but this has happened a few times now.
-
Hey everyone been following for a while. Just wanted to know if there was a part number for the extractor and spring. I skimmed back through a few pages just must have missed it. Post # 2077 has both part numbers. page 84 of the thread, top half Oh man! I looked right past that. Thanks.
-
Hey everyone been following for a while. Just wanted to know if there was a part number for the extractor and spring. I skimmed back through a few pages just must have missed it.