SchuhmTi

Hopefully they will make a .356" version for plated bullets to. All the M-dies and also the dillon swage hold down die are made for. 355" bullet diameter. The brass springback is so much that the plated bullets fall of the case.

If I need to decide, I would automate the processing. Loading pre processed brass is no big deal, but the heavy crimped primers and wide brass takes more force to beat. And if you got a ton of processed brass loading your weekly dose is a fast Business.

WD40 5l can from europe It's just for processing They get cleaned with water, bacause of sand and dust. Than rollsized, a spray of WD40 than deprimed, sized, swaged. Cleaned untill shiny and dried One batch is like 10k I would never load sticky cases with new primers or powder

WD 40 for 9mm and .223 at an automated Dillon 1100. Over 10k on each without issue. Easy to clean the cases afterwards and the casefeederbowl can be just whiped with a tower.