Roll pin sizes on EAAs

[Craigar45]

Anyone know the sizes of some of the more common EAA roll pins? LIke the hammer, trigger, trigger bar, etc. Thanks!

C

[lmlong]

It would be easier just to go to Hennings store and order them there.

Larry

[Craigar45]

I know he carries them, and no offence to Henning, it is just that I have a big order to place with Brownells and I can get a bunch for dirt cheap. So anyone know?

C

[BritinUSA]

I got some roll-pins a while back from another supplier and had problems with them. So I ordered some from Henning and they fit much better and seem to be better made too.

From my collection:

Extractor pin is .556 long and .104-.105 diameter

There are two trigger pins, both are .104-.105 diameter, long one is .712, short one is .322

The trick here is that the roll pins in Tanfoglio's are METRIC, this is probably why the similar ones I found were not as good.

I understand you're putting in a big order to Brownells but if it were me, I'd get them from Henning, that way you KNOW that they are exactly the right size.

[Craigar45]

I got some roll-pins a while back from another supplier and had problems with them. So I ordered some from Henning and they fit much better and seem to be better made too.

From my collection:

Extractor pin is .556 long and .104-.105 diameter

There are two trigger pins, both are .104-.105 diameter, long one is .712, short one is .322

The trick here is that the roll pins in Tanfoglio's are METRIC, this is probably why the similar ones I found were not as good.

I understand you're putting in a big order to Brownells but if it were me, I'd get them from Henning, that way you KNOW that they are exactly the right size.

Ah... Thanks for the info Brit... Hadn't considered they might be metric.

C