Albertl35 Posted September 19, 2007 Share Posted September 19, 2007 I just got in 2k of 9mm Starline Brass and have noticed that some are very tight and needs to be reemed by a primer pocket tool while others are fine. I estimate that about 20% are tight and 5% very tight. I also got 2k of 40SW Starline brass and they are fine (random check of 20 cases). Anyone with this exerience? I would expect that the chrono will show a wide extreme spread and high SD on the 1st 150 rounds that I loaded with the Dillon 650. I had go over them with a hand held primer seating unit to get them flush. This did make me a little nervous since it is a loaded round. Link to comment Share on other sites More sharing options...
BritinUSA Posted September 19, 2007 Share Posted September 19, 2007 If this is new brass then I suggest you contact Starline, they have very good customer service and I'm sure they would want to remedy the situation. Link to comment Share on other sites More sharing options...
Albertl35 Posted October 16, 2007 Author Share Posted October 16, 2007 Correction, the brass was not Starline as I thought. I reached a got a bag of brass, turned out that these were new Hirtenberger 9mm brass. The primer pockets are not uniform, some are tight and others are loose. I have some Starline and they are far more consistent. Link to comment Share on other sites More sharing options...
Harmon Posted October 31, 2007 Share Posted October 31, 2007 starline are the stuff. the best brass imo...i just cant afford it. Harmon Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now