Rival +X% strength magazine springs?

[uhmeebuh]

Hi all - 

 

I have a Rival polymer I'm using this season to...uhh...re-remember how to shoot after a few seasons with a 2011 that taught me some bad habits

 

I'm using the Henning basepads and some of the MBX followers and springs...but I'm having some FTF issues with the followers as they tilt down.  I ruled out the recoil spring as it's plenty strong for lock up (and very close to factory spring weight) and I wanted to see if a heavier +10% or more spring exists to help with the pressure on the bullets upwards.  I'd like them for the MBX follower but I assume this is...not possible.

 

Anyone run into this or have suggestions?

 

Thanks!

Edited July 15 by uhmeebuh
Added details on which follower for max capacity

[Thomas918]

Yes Taylor freelance sells +10% springs. It what I have used for the past 2 years with my +4 extensions. You do lose 1 round of capacity though. They are made by Wolff.

[uhmeebuh]

On 7/17/2024 at 12:53 AM, Thomas918 said:

Yes Taylor freelance sells +10% springs. It what I have used for the past 2 years with my +4 extensions. You do lose 1 round of capacity though. They are made by Wolff.

 

Thank you!  I'm trying to not lose capacity but what good is 24 jamming rounds?

[Chutist]

MBX should have the springs:

https://www.mbxextreme.com/index.php?page=Magazine_Parts_Canik

 

I think Henning sells them too:

https://www.henningshop.com/HenningGroupMagazineSprings_it-1522729.aspx