Petrov Posted December 28, 2022 Author Share Posted December 28, 2022 The cylinder face was off by 0.004. Link to comment Share on other sites More sharing options...
pyrrhic3gun Posted December 28, 2022 Share Posted December 28, 2022 A knowledgeable revo smith will square the cylinder between a mandrel and a center in a lathe. Then set the barrel back enough to be able to square the end of the barrel while establishing the proper gap. Find somebody that can do it. Link to comment Share on other sites More sharing options...
Petrov Posted December 28, 2022 Author Share Posted December 28, 2022 2 hours ago, pyrrhic3gun said: A knowledgeable revo smith will square the cylinder between a mandrel and a center in a lathe. Then set the barrel back enough to be able to square the end of the barrel while establishing the proper gap. Find somebody that can do it. Already have the cylinder taken care of. The guy who did the revolver conversion is knowledgeable too probably just a small missed detail as most PPC conversions are done on old pre lock model 10 and new smith and Wesson's are made out of a mixture of s#!t and butter. Link to comment Share on other sites More sharing options...
Petrov Posted January 2, 2023 Author Share Posted January 2, 2023 Got my cylinder back from Toolguy! Now the barrel and cylinder gap is perfectly square and consistent. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now