Forensics Doc Posted February 5, 2021 Share Posted February 5, 2021 I'm trying to disassemble my Rockchucker Supreme for cleaning and lubrication. The older versions had a toggle block pin that went through the lower holes in the linkage arms and were secured with a c-pin thingy. With the new one, the toggle block pin through the lower holes in the linkage arm are secured on either side by nylock nuts. I can get one off at a time but when I try to get the other one off, the one I just got off tightens. I've tried holding the threads of the side I got off with a wrench with a piece of cardboard over the jaws so I don't screw up the threads but can't hold it tight enough to allow me to remove the nylock nut on the other side. Since this is a continuous pin, can I just take off one nut and drive the toggle block pin to the other side using a hammer? If so, do I drive it right to left or does it make any difference? Link to comment Share on other sites More sharing options...
RePete Posted February 5, 2021 Share Posted February 5, 2021 Looking at the manual, it looks like the pin will go out either direction. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now