saibot Posted October 10, 2017 Share Posted October 10, 2017 I had to work a bit to get the Walther's PPQ magazines to fit properly with my CR Speed mag pouches and thought I'd share with the forum. I tried to use a washer behind the STI insert, but it I had to use a pretty big washer that just didn't look like it was going to stay put. I played with the other inserts but they were all just a bit too small except the CZ insert which was a little too big. Measuring them with the calipers, they measured 0.3225 thick. Working them down a bit with a file I found the spot where they seemed to have the proper tension and still allowed for more to be added via the tension adjuster. 0.3160 seemed to work best. Here's the "before" picture. Be sure to file off the side that will make contact with the magazine, the left side in this image. Anyway, hope this helps anyone who wondered if they could use the CR Speed pouches with the PPQ. Link to comment Share on other sites More sharing options...
MemphisMechanic Posted October 10, 2017 Share Posted October 10, 2017 (edited) I did the same thing to fit PPQ mags to the CRSpeeds for my girl's rig. While you're dremeling on them, shave the top of this spacer down at a 45* angle. It makes inserting mags into the pouches much, much easier. Edited October 10, 2017 by MemphisMechanic Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now