Mag base pads

[Focker]

I decided to try some base pads from springer precision for my CZ mags.  I have the original 18 rounders and I ordered the base pads for them.  When they arrived I tried to put them on and they are extremely tight.  I can get them on but it takes some serious effort and there is a little gap at the back of the mag like the pad isn't going on all the way but the tab clicks into place.  To get them off is very hard.  I had to use pliers, the edge of the table, and a lot of force to do it.  

Is this normal or should I contact them tomorrow?  

I really don't want to have to go through what I did today to get one off and back on every time I drop one in a puddle at a match and need to clean my mag.

Edited September 11, 2016 by Focker

[S&W686]

I had the same issue with springer precision base pads for my CZ and Mec-gar magazines.  A couple of them were not too bad to get on or off, but most fit very tight.

[FTDMFR]

The anodization might be too thick on either the basepads or your mags.

You might need to sand a little bit of material off the bottom of your mag lips.

[Focker]

Thanks for the tip.  I didn't get a chance to call Springer or mess with the mags today but that's a good idea.