Nick S Posted July 20, 2016 Share Posted July 20, 2016 (edited) I tore down my trigger group from my TTI M2 and after reassembly this was left over. To clarify I'm referring to the piece above the safety plunger. I disassembled it again and went through to make sure I didn't miss anything. I checked the schematic and nothing. It is the same diameter as as safety plunger so was thinking it may go in there but not sure of the purpose? Any ideas? Thanks. Edited July 20, 2016 by Nick S Link to comment Share on other sites More sharing options...
kurtm Posted July 20, 2016 Share Posted July 20, 2016 It is an over travel device that TTI uses to limit trigger over travel. It goes around the pin that goes through the back of the trigger housing where the little square cut out at the back of the trigger rides. It is kind of a bitch to install, but that is where it goes. Link to comment Share on other sites More sharing options...
Nick S Posted July 20, 2016 Author Share Posted July 20, 2016 Thanks Kurt. I appreciate it. Link to comment Share on other sites More sharing options...
kurtm Posted July 21, 2016 Share Posted July 21, 2016 All part of the extensive knowledge of the Benelli system at your finger tips! RNT baby!!!! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now