Jody Waring Posted May 19, 2016 Share Posted May 19, 2016 I am looking at drilling my Tactical Sport frame for a thumb rest. Could someone share with me the hole locations on the frame on a czechmate just so that in the future if this frame is used for something else I don't have an odd set of holes in the frame. Would I be better drilling to the same pattern as a Tanfoglio? Link to comment Share on other sites More sharing options...
kneelingatlas Posted May 19, 2016 Share Posted May 19, 2016 I drilled my two CZ Open frames with the CM pattern: (3) M4x0.7 holes 15mm on center. The Tanfoglios share the first and last holes with (4) on 10mm centers. Link to comment Share on other sites More sharing options...
phoenixsomd Posted May 19, 2016 Share Posted May 19, 2016 I have the CZ Customs jig and can measure the hole layout for you. The jig indexes off the slide release/stop location. I'm going to be away thru Sunday so, I will have to wait till Monday to send the information your way. Link to comment Share on other sites More sharing options...
Jody Waring Posted May 19, 2016 Author Share Posted May 19, 2016 Thanks for the replies and info guys! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now