galt11 Posted May 1, 2014 Share Posted May 1, 2014 On my latest two Glocks, a 17 and a 30 both Gen4, the safety nub on the trigger seems a bit more proud than on my others. Is there a better way to "wear" it down just a bit. Thanks Adam Link to comment Share on other sites More sharing options...
a.roberts Posted May 1, 2014 Share Posted May 1, 2014 Sandpaper. Unless you're shooting Production, in which case, leave it alone and get used to it. Link to comment Share on other sites More sharing options...
galt11 Posted May 1, 2014 Author Share Posted May 1, 2014 Sandpaper. Unless you're shooting Production, in which case, leave it alone and get used to it. It would be for production. I dont want to remove it, but just make it a bit less protrusive. Link to comment Share on other sites More sharing options...
alma Posted May 1, 2014 Share Posted May 1, 2014 You shouldn't be modifying it if you want to stay production but... Remove the trigger and trigger bar from the gun and pull back on the part of the trigger safety that contacts the frame. This should expose more if the part you want to profile. From there I used a fine sanding drum on a dremel but anything else would likely work as well. Profile of taste. Enjoy. Link to comment Share on other sites More sharing options...
galt11 Posted May 1, 2014 Author Share Posted May 1, 2014 You shouldn't be modifying it if you want to stay production but... Remove the trigger and trigger bar from the gun and pull back on the part of the trigger safety that contacts the frame. This should expose more if the part you want to profile. From there I used a fine sanding drum on a dremel but anything else would likely work as well. Profile of taste. Enjoy. Thanks. I think that procedure and some 2000 grit sandpaper is just what the doctor ordered. Just enough to take some of the bit out of the safety. It almost appears as if the nub has already been profiled to a knife edge. Link to comment Share on other sites More sharing options...
LoganbillJ Posted May 1, 2014 Share Posted May 1, 2014 Using a knife to slowly scrape away at the leading edge is a quick and easy way to remove some of the protrusion as well. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now