sandrooney Posted February 26, 2014 Share Posted February 26, 2014 (edited) How do you install the pin in the hammer and strut it is to big for the hammer but fits the strut fine. ??? Thanks SR Edited February 27, 2014 by sandrooney Link to comment Share on other sites More sharing options...
donnyglock Posted February 27, 2014 Share Posted February 27, 2014 Put it in a drill and spin it in some 220 or 400 sand paper. Spin it a little then check rinse and repeat. Link to comment Share on other sites More sharing options...
openmike Posted February 27, 2014 Share Posted February 27, 2014 .157 reamer. Brownells has it Link to comment Share on other sites More sharing options...
sandrooney Posted February 27, 2014 Author Share Posted February 27, 2014 Thanks a lot. Link to comment Share on other sites More sharing options...
mildot1 Posted February 27, 2014 Share Posted February 27, 2014 Actually You need to measure the pin, I just checked one and it was .1545. I have a .154, .156, and a .157 on the bench. I prefer to keep the holes as tight as possible and drift the pin so I use one reamer to go through both sides that is tight to the pin dim. Then I use one that is slightly larger and come through one side and start into the other. That keeps the pin from falling out when tearing the gun down. FWIW Mildot Link to comment Share on other sites More sharing options...
sandrooney Posted February 27, 2014 Author Share Posted February 27, 2014 I borrowed what I needed from a friend that has a machine shop and got it done. Thanks for all the help, SR Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now