poopshooter Posted January 23, 2014 Share Posted January 23, 2014 when i got the gun the pin block safety was stuck in the depressed possition i have tried poking back out thru the pin channel with a very small stiff wire but it will only drop down less than a 16th whne i try to get needle nose on the extruding nub well its just not quite enough material to get a tug anyone seen this or have an idea that may help me get it fixed? thanks -Craig Link to comment Share on other sites More sharing options...
cindynles Posted January 28, 2014 Share Posted January 28, 2014 (edited) You may have to remove the rear sight so that you can get to firing pin block and spring from the top. It sounds like the spring may be bound. Can you remove the extractor from the slide? Edited January 28, 2014 by cindynles Link to comment Share on other sites More sharing options...
poopshooter Posted January 29, 2014 Author Share Posted January 29, 2014 i got some help locally, all set now thanks Link to comment Share on other sites More sharing options...
cindynles Posted January 29, 2014 Share Posted January 29, 2014 So what was the issue? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now