pining_garcia Posted September 17, 2011 Share Posted September 17, 2011 Hey guys! I recently purchased an STI stippled grip online. I put it together and noticed that when you load the mag, something is catching and doesn't go in smoothly. Aside from that, when you press the mag release button, the screw on the other side turns and the mag release button eventually gets stuck. Seems like the groove inside where the spring of the mag release button locks, is not aligned. Has anyone had this prob? Should I send it back to the place where I bought the grip from or send it to STI since it's an orig STI grip that was modified? Thanks! Link to comment Share on other sites More sharing options...
gng4life Posted September 17, 2011 Share Posted September 17, 2011 Did you change out any other parts, like the mag relaease, trigger, etc.? Are you sure this didn't happen to your original grip? At what point is it catching? Link to comment Share on other sites More sharing options...
pining_garcia Posted September 17, 2011 Author Share Posted September 17, 2011 I messed up the orig grip on my STI trubor by shaving it down too much then stippling it. The grip became weak and its caving in when you're trying to release the mag. Nothing was changed/added except for the grip. Aside from the mag release button getting stuck, the actual mag also gets stuck that you have to pull it out hard to get it out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now