sauza45 Posted September 6, 2011 Share Posted September 6, 2011 Cleaning my gun and found the firing pin stop is cracked. I have fitted the new stop and I matched the radius to the old one, but the angle left to right on the bottom edge is not square? It is not out by much but it is out of square. How importent is this to be square. I can file the bottom up to square it up but then it will be shorter than the slide. Do I need to fit a new one? Link to comment Share on other sites More sharing options...
ParaGunner Posted September 6, 2011 Share Posted September 6, 2011 If it's to uneven it could wear the hammer and hammer pin uneven. A few good pictures of your FPS and slide would help see what you got. Link to comment Share on other sites More sharing options...
sauza45 Posted September 7, 2011 Author Share Posted September 7, 2011 Thanks I will post a picture in the morning. Link to comment Share on other sites More sharing options...
sauza45 Posted September 7, 2011 Author Share Posted September 7, 2011 It is hard to see but the edge of the radius is not square. I might try to square it up before I get another one. Will the angle of the radius damage anything if not square? Link to comment Share on other sites More sharing options...
BlueOvalBruin Posted September 7, 2011 Share Posted September 7, 2011 Square that sucker up. Link to comment Share on other sites More sharing options...
sauza45 Posted September 7, 2011 Author Share Posted September 7, 2011 I worked on it some more it is square now and the fit is good. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now