freakshow10mm Posted September 13, 2010 Share Posted September 13, 2010 For those loading pistol ammo on a Super 1050, what handle position do you have? Here in the picture is the one that gives the shortest throw, the one closest to the handle. The notch closest to the end is the longest throw. What do you have yours set to? Link to comment Share on other sites More sharing options...
Bigpops Posted September 13, 2010 Share Posted September 13, 2010 I have mine in the middle slot. Keep in mind to check for clearance with your bench, with the handle fully down. From your photo I cannot see how close you are to the edge. Link to comment Share on other sites More sharing options...
Bill H Posted September 13, 2010 Share Posted September 13, 2010 I have mine even lower than the low hole. I wanted a short pull. Works well as long as it is lubed pistol brass. Link to comment Share on other sites More sharing options...
freakshow10mm Posted September 13, 2010 Author Share Posted September 13, 2010 I have mine in the middle slot. Keep in mind to check for clearance with your bench, with the handle fully down. From your photo I cannot see how close you are to the edge. The handle will touch the bench when the toolhead is fully down. Link to comment Share on other sites More sharing options...
Bill H Posted September 13, 2010 Share Posted September 13, 2010 I cut the bottom of the handle rod to get mine lower. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now