jjmo
-
Posts
10 -
Joined
-
Last visited
jjmo's Achievements
Looks for Range (1/11)
-
The last picture just reminded me of a possible issue. If you were to mirror the rest on the other side (I'm a south paw) the ejected brass would be an issue?
-
Thx atlas, will do
-
I think I might try and get my hands on a similar metal and practice just to be safe. I do a fair amount of re tapping (on cars) at work but not from scratch. But thanks again for sharing the work it's a sweet TS. I was starting to think the frame might be a bit too much.
-
Look out I'm diving in!!! Thx
-
Yea I think for small hands it would be a great improvement for sure. Now the question is, to send it to gunsmith or build up the courage to a DIY project on the frame. Maybe just I'll have it done, it would be hard to fix if I jack it up I would think. Unless somebody thinks it's not too bad...
-
I think it is the CR Speed thumb rest I got it from Max's Choice.com As far as positioning, I just wanted it as close to the rear as possible without it interfering with any controls. Normally I wouldn't go for something like that but, it really did make a night/day difference when trying to grab a hold of that really wide frame the TS is famous for. Thanks for sharing your great looking project! I just picked a ts and found my small hands not getting quite the bite I was hoping for, even with the thin grips. Is there any special tools other than a tap and drill needed to mount the thumb rest?
-
Thanks for the input, mine comes in on Thursday or Friday can't wait! Really looking forward to it.
-
Hey twister, Midway has the rear sight, I'm still looking for the front one somewhere...hope that works for ya
-
Thanks, Im looking foward to throwing some rounds outta this thing!
-
New to the forum and waiting on a TS in 9mm to come in (next week). Have been doing research on things to tinker with. I have found some information on recoil springs, but its either in reference to .40 or a heavier 9mm than I have access to. It's just the plain jane 115 grain target ammo, for now.... So, I planned on swapping the guide rod out with one from the custom shop, but what recoil spring should I use? Or maybe just use the stock one? Thx for the input in advance;)
