Yes it says crimp die, I thought same thing set dies up per instructions and wen I started adjusting every little turn produced no diffrence until it starts popping. This is what I found on dillons we site.
"
Hello everyone,
I just got my 550B a couple of days ago and had a buddy come over and help me setup. I have experienced a problem with the crimp die binding. The bullet will bind when coming out of the crimp die and will have brass shavings on the case. The crimp measurement is .471 ish. Also, I tried backing out the die until it doesn't bind anymore. However, at that point it won't fit into the case gage. Any help would be greatly appreciated."
"Hey everyone. Looks like it was the die. My buddy has been reloading for about 4 years and put my crimp die in his machine and it was doing the same thing with the binding. Then he put his die back in and it was fine. He used my brass and bullets to recreate the same scenario on his machine as mine. So, I'll be calling Dillon, hopefully for replacement. It sounds like their customer service is top notch."
Mine looks the same as he describes he also goes on to say he contacted dillon and they new what he was talking about and was sending him replacement insert. Thanks for suggestions.