tires2burn
-
Posts
410 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by tires2burn
-
-
sock for me to.
-
Can the 1050 pins be used on the 550
-
Cleaning the powder drop will probably solve your problem.
-
10 pulls to start out and if I go have lunch or stop for any reason, when I return I always pull 3 or 4 drops & check before I continue.
-
About five min in a corncob tumbler cleans the one-shot off and makes them look new. I have noticed that if I store them is a zip lock after a while the one-shot gets sticky so that's why I clean them.
-
Got one of these last week and it makes a smooth running primer bar. I can fab pretty well but the price of this upgrade is well worth it. I marked the bearing with a marker and every pull spins the bearing coming out & going in. Great piece.
-
Can you use SRP in place of SPP magnums? Since the SRP are for a larger case with more powder would they work with 357 mag. I ran out of the magnum primers for my 357.
-
I have a few of the Dillon head covers I'm not using. I went a different route.
-
-
I use TG and it shoots cleaner if you step up the charge.
-
They didn't send me a new one and explained that since the frame was ruined not much was left to replace. I expected that answer.
-
I talked to S&W and when I explained how bad it was they told me not to bother sending in in.
-
I had a similar problem. One squib and one double charge. I changed my loading routine since this happened.
-
Gamaliel Shooting Supply has Titegroup in 4 & 8 lbs.
-
it seems to happen on full mags.
I load my 9mm to 1.18 OAL.
That's pretty long for a 9mm.
What gun and bullet are you using to load that long?
I just tried a 1.180 in my case gauge & it hung out the bottom.
-
I usually load up my shell plate and pull the handle down to seat all the stations and loosen each die just enough to center the die and then tighten back down. This seems to eliminate any misalignment for me.
-
It's been my experience that slower powders will fill a case to a greater extent than fast powders.
Your right Steve. I got it reversed.
-
Go to a faster powder and it will fill the case and be easier to see.
-
I fabed a strong mount ans added a bracket to hang my bullet bin on.
-
Your right on the OAL that Hornady lists. If they cycle ok run them. My 45"s run at 1.250 with a 230 RN and anything shorter causes cycling problems.
-
Clean your dies.
-
Thanks for all the info guys but this reminds me of hearing where the fish are biteing and when you get there the bite is over.
-
I have 7,500 Remington 130 gr FMG RN bullets advertised on box as being .356 for 38 Super. Almost all are coming in at .354". I can't return them because I bought them so long ago, I can't remember where I got them. They drop too deep in my 38 Super case to get a good crimp and fit...
Anyone had this problem? Can I use them in 9mm with no bell? I have tried to contact Remington directly but just get an automated response from emails referring me to a Dealer...anyone have a contact at Remington? It appears I will sell them for scrap....c
Marine Corp
Colonial Shooting Academy
I just ran two 9mm cases through my Lee Undersize sizing die & they both sized to .345 inside diameter. I get zero setback and crimp just enough to get the bell out.
-
Get a U-die from Lee for 9mm and load em up.
new 550b problem
in Dillon Precision Reloading Equipment
Posted
The wire will move up or down.