sti38super

SCGC this Sunday 6 Stages 180 rds, Classifier CM 06-03

SCGC will shoot this Sunday the 5th. 7 Stages 182 rds. 9am sign in Shot at 10am.

7 stages 184 April 3rd 10am.

SCGC USPSA Match Sunday 6th. 6 Stages 175 rds. Classifier 99-46 Set up Sunday at 8am. Go Hot at 10am

The match has been changed to Saturday the 20th because of rain predicted for Sunday.

SCGC will shoot USPSA this Sunday the 21st 6 Satges 172 rds. Classifier 99-13 Sign in at 9am Go Hot at 10am

SCGC USPSA Match this Sunday the 7th 182 rds. 7 Stages Sign in Starts at 9am and we Go Hot at 10am.

It really makes a difference in the bullets. .355 FMJ vs .356 coated . .355 will not hit the rifling as much as .356.

7 Stages 180 rds. Classifier 13-01 Set up Saturday at 10 am Sign in at 9 am Sunday Go Hot at 10am.

How The trigger bar moves up and bottoms out on the sear cage, so your contact point is always the same no matter how long the sear leg is. The trigger pull weight has so many contributing factors that I doubt its a leverage issue with the TS having a lighter pull weight. I can make a Tanfoglio with a .5lb trigger pull without touching any springs, using the stock compone How can you do that with stock spring?

I guess no one has tried to drill and tap a Limited Pro trigger for an over travel screw.

So by shortening the sear leg the trigger bar should reset sooner, Correct?

It can't all be the Hammer hooks, the click you hear when the trigger resets is the trigger bar being pushed up in front of the sear leg. Some way this is what determines the amount the trigger moves forward before resetting.

How do you get a shorter reset in SA with the Limited pro with the stock hammer and 1 peace sear. I have a T3 disco and reduced the pre travel but the trigger travels a good1/8" for SA reset. I have handle Tanfo's with the Titan hammer and they seem to reset a LOT quicker. Any Ideas.

Is the Limited Pro Trigger Hardend? Can you drill and tap one and put in a overtravel screw like the Stock 2 and Stock 3 have.

SCGC October match this Sunday the 4th 7 Stages 172 rds.

SCGC pre Indiana State Match--- MATCH September 6th. 6 Stages 188 rds. All stages from Indiana State stages. Sign in starts at 9am Sunday. Shooters meeting at 10am.

Support hand thumb is touching the frame in front of the slide stop and with minor loads the thumb does not move from the frame.

Wrong on all accounts so far. My thumb can not reach the slide stop when shooting. The grips are a mile away from the slide stop.

This is a new Stock 3. If it were a 1911 I would put a detent in the slide stop.

Stock 3 goes into slide lock when rapid firing. Any suggestion?

Any one know where I can get a Ghost holster for a stock 3?

My mistake I was referring to the take up.

So does the Xtreme disco have as short a reset at a CGW T3 after fitting?

Silver Creek is cancelled so SCGC will hold a 6 stage 192 rd No Match on August 9th Set up at 8am Sunday, Sign in at 9am Go Hot at 10am.