Jump to content
Brian Enos's Forums... Maku mozo!

burket

Classified
  • Posts

    60
  • Joined

  • Last visited

Posts posted by burket

  1. I have been using HP38 / Win231 for several years. I know of NO temperature sensitivity.

    BUT there have been letters published (reportedly from Hogdon) that HP-38 / Win231 is being dropped from production in the next few years. I have seen the letters, but I have no idea how accurate / reliable these stories are. I continue to use this powder. Best wishes.

  2. I've used those a couple times, but never bought them. I just sort the (up to) several hundred cases immediately after my range time. And I just go thru them by hand. It takes maybe 15-30 minutes.

    Hope that helps.

  3. ES13Raven

    I also use crushed walnut.

    I usually run several thousand 9MM or 40S&W brass thru it, in several different loads. Usually about 500-1000 pieces of brass at a time. The crushed walnut may last 3-5 times. When it is discolored (based on looking at new crushed walnut), I toss it.

    I use new dryer sheets, as I don't use them in a dryer at all. I throw them away when they have picked up a lot of dust! usually about as long as the crushed walnut lasts.

    And I don't use any additive, but I also don't care about shiny brass, just clean!

    Hope this helps!

  4. I have a CT laser on my EDC (G17), and a different CT laser on my G22 Gen 4. Both of these are the buttstock version of the CT laser. I had a problem with the laser on the G17 failing to turn on, about 6 month after I bought it. CT had me ship it back to them. I don't know if they repaired it, or replaced it, but I had it back in less than 2 weeks (no Charge, except one way shipping).

    I have had both of these lasers for over 2 years now, and had NO other problems. I shoot multiple times a month.

    I also have a CT laser on my new G42. It sits forward of the trigger, under the barrel. And I have had no problem with it either. (Of course, I've only had it about a month!).

    I like the CT lasers!

×
×
  • Create New...