I have been loading on an xl 650 for some years now. I load primarily 9 and 223, but have conversions for trimming 223-300 bo, and 45 acp. The press works well and theres been pretty much no issues, and the issues i have had were fixed, for free, by dillons absolutely top notch customer service. I would really like to add a bullet feeder into the mix, but dont want to lose a powder check or my factory crimp die which is where the dilema starts. On press swaging is a huge plus too as i will no longer need to mess around on the lee app (have tried and hated the swageit) Logically, i was looking to get a press to fix my gripes. The likelyhood of me running an auto drive is pretty low in the future as a talking point. Have any of you used both and have inputs on what you did and did not like? The pricing is pretty apples to apples at this point between the two. Im really hesitant to walk away from dillon as they have really went above and beyond to help me. I would have the press set up once a year for a big run of 223 and the rest of the year be setup for 9 if that helps.