35 Doubled Once

[dawg23]

Skeeter,

I always say that you can do any two of the three trigger mods listed below, but never all three at once. I just don't trust it.

- Light striker spring

- relocate hole for trigger return spring

- extra power trigger return spring.

Any combo of two of those, but not all three.

I did #1 (Wolff) and #2 (CV trigger) plus a polish job on my G19. Had a 2 lb 2 oz. trigger.

No problems for the first 10,000 rounds.

But then the occasional double if it wasn't very clean......

Then more frequent doubles if not very clean....

Then the occasional doubles even when clean.

Bought a new connector (Ghost) and a new (Glock) striker. Then it doubled every[/u[ time. Second shot fires when you release the trigger.

Never could figure out the problem. Called Charlie and bought a new trigger. Problems went away. I can only assume I over polished the trigger cruciform and/or the tang.

I still have a 2 lb. 2 oz. trigger. And a "spare" CV trigger in my parts box.

[Flexmoney]

My guess there would be that you rounded or decrease the "sear" portion of the trigger bar...where is contact the striker tang.

[mightymouse]

i did some polishing and im getting 2 shot burst and the trigger wont reset

what if you bend the sear up alittle so it will reset ?

yes or no

[mightymouse]

i anwsered my own question with a friends gun i started changing parts and found the disconecter was bad i guess we shouldnt play with stones and disconnecters

some people just learn the hard way

[kevin c]

The 35 doubled again a couple times, but only twice. While there's an RS trigger kit in it, I don't think that's the problem. This time it was on WHO drills with a hand transfer, so my grip may not have been as good as it should have been.

Overall, I'm thinking that my own doubling problem is grip related trigger reset or trigger finger bounce.