ARMAGEDON Posted December 3, 2017 Share Posted December 3, 2017 Good morning everyone. I recently bough a Tanfoglio limited 40S&W. I will use it for USPSA. I have two size of bullets 180 and 200 gr. Bullets are coated from SNS casting. I use Hodgon Titegroup. I want to make them at a size of 1.15. With that bullet, powder and size what powder measurements do you recommend? I search for this but couldn't find it. I think this topic already exist here but i'm really bad searching. Thanks everyone for your support. Link to comment Share on other sites More sharing options...
Jmoreno88 Posted December 3, 2017 Share Posted December 3, 2017 Better off asking in the reloading section. This is classifieds for salesSent from my SM-G955U using Tapatalk Link to comment Share on other sites More sharing options...
ARMAGEDON Posted December 3, 2017 Author Share Posted December 3, 2017 Thanks J Link to comment Share on other sites More sharing options...
Jmoreno88 Posted December 3, 2017 Share Posted December 3, 2017 Thanks JNo problem. FWIW when I loaded 40 at 1.2, loaded around 4.8gr. Considering you want to go deeper then you will increase your pressure so I would suggest starting about 4gr maybe a tad less and chrono it and see if you like it. Reloading is very subjective to the pistol set up (barrel length, etc.) more so than the round. Sent from my SM-G955U using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now