Tell me about your Limited setups

[ny32182]

Limited for Limited, .40 major... I'm just wondering what all your spring rates are, and if there are any "must have" modifications, etc... Go.

[ATLDave]

There's no reason whatsoever you should pay any attention to what I have done with my gun, but mine has a Henning magwell, grips, and front sight on it, and a DAA adjustable thumb rest.

[ny32182]

So no internal mods? Trigger does seem to be shootable to me out of the box, but I have made some changes for me as a lefty:

22lb Plunger spring (it was the only one I had left from the kit), 14lb hammer spring, CGW trigger return spring, removed firing pin safety plunger, cut down the stock firing pin spring a bit, and did some minor internal polishing on the plunger components and trigger bar. This all reduced the trigger pull slightly but not much.

Also installed Stock 2 size safety, Henning guide rod, Henning firing pin, swapped magazine catch to the right side as always.

I think it is ready for load development.

Edited March 9, 2016 by ny32182

[eern]

I love the DAA thumb rest and would also suggest an EGW sear. You have to shape it yourself, but you can take out a lot of the reset travel. I also use coppergungrips.com as they are almost a 1/4" thinner and have an aggressive grip.