Jump to content
Brian Enos's Forums... Maku mozo!

Arridondo speed chute on a CZ 712 and gas port size, better springs th


mikeAZ
 Share

Recommended Posts

Yes, I know....puts you in "open"... Doesn't matter to me..... ANYONE done this????

I have a small mill (named the "destroyer") and access to a heli-arc welder. I'm certain I could botch this up!!!!..........Ralph, I hope I spelled your name right????.... I've read the posts on opening the gas ports for puffer loads... A little confused on the exact size.. Is it .006 over the stock size or what? .Are the after market springs still available?

I measured the gas ports, .1085.... one had a slight burr I removed... was looking to use 1145/1180 FPS x 3 1/8 oz. x 71/2 shot.

Edited by mike NM
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...