Skynyrd Posted August 26, 2011 Share Posted August 26, 2011 With the dillon casefeeder connected atop of the casepro... I taped a small flashlight on to the tube so that it shines down to the casepro so I can clearly see down into every case as I work the casepro. Gravel can get stuck in the cases that the tumbler will not get out. Saves on breaking decapping pins when it gets to the sizing die. Link to comment Share on other sites More sharing options...
jmorris Posted September 9, 2011 Share Posted September 9, 2011 Here is another one, I came up with when I automated one. From time to time a case rides back with the dies, to prevent this I use foam tape to push the case off at the end of the stroke just a bit. If you use double side foam tape make sure you stick something like a thin section of plastic to the outside edge. Arrow Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now