Waylonspapa

Thanks guys for your help!

Unless I've overlooked it, it looks like all of the loads referenced here apply to the higher-end pistols. I used similar loads for my STI but have switched to a G35 for my backup for IDPA matches. That said, has anyone used either the N320 or N310 for .40? Thanks

I'd like to make my S&W 686 able to accept moon clips. I need recommendations for gunsmith who can mill (?) the cylinder. Thanks!

I have a Remington 1100 Tactical I use for 3-gun. I need a good gunsmith who can modify or change out the lifter. Any suggestions would be appreciated.

Correct-OAL is 1.155

And my dies are the Dillon ones

OAL is1.55" Crimp is .385" Bullet is MG 124 gr Barrel is Stormlake

I load 9mm using my 550. I rarely get a perfect fit when I use a chamber gauge. I have a custom barrel in my G34 that I can't use because the rounds won't chamber/seat all the way. When I decap & resize, the brass drops perfectly into the chamber gauge. Since the bell of the brass is expanded by the powder funnel, and since I can see if the problem exists after seating the bullet, I surmise the problem is with the crimp die. The reloaded rounds typically extrude at the base about 1/32" of an inch. They work fine in the factory barrel, but not the custom barrel. What do I need to do to get the reloads to work correctly? Thanks! Ken