hi all, new member here
I like the travel stop.
Its takes a little while to get it adjusted.
(be sure to double check and make sure your gun is not loaded).
Remove the slide and install the travel stop.
turn the screw in until about 1/8 of a inch is sticking out.
install in the gun and dry fire 10-20 times.
(be sure to double check and make sure your gun is not loaded).
Next remove the slide and the rear pin holding the ejector, raise the ejector out of the receiver just enough to adjust the screw inward.
Only turn the screw a 1/4 turn and put the gun back together and dry fire 10-20 times.
Repeat the steps until the trigger starts to fill hard to pull.
At this point back off the screw 1/8-1/4 turn and you are done.
A little locktite is a good ideal as someone else noted.
If for some reason you go to far, the gun will not reset and you cannot take off the slide.
In this case, simpley lock the slide back, remove the back plate and the stricker. While holding the slide and receiver in one hand release the lock and take off the slide. Put it all back together and start over again
Good luck