So after waiting a long time, I finally got my .45 ACP longslide conversion for my witness match. Apparently I didn't know that I had a choice of wonder finish (what is it?) and blue, and ended up with wonder finish. Slide goes on my match frame no issue. But the joy was short lived.
I have two issues, and I don't know if it is a gunsmith issue, or one where I need to send it back to EAA.
Issue #1: Either I need to go back to disassembling a semi-auto pistol school, or this barrel was pressed into the slide because I can't seem to get it elevated enough to clear the back of the breech and get it out of the slide. The recoil spring and guide rod come out just fine. This could be an issue for cleaning lol. Has anyone else had this issue? From what I can tell there isn't enough room by the fwd end of the slide to allow the barrel to rotate enough to get out of the slide. I am guessing this is not normal and would not be able to be fixed without taking material off and refinishing the slide. So this might require return to EAA?
Issue #2: It appears that the lug on the bottom of the barrel is slightly undersized against my current slide stop pin, because if I take the pin and put it in the lug it is a VERY tight fit. This seems to make it incredibly notchy going in and out of battery as the slide goes back and forth. I have only run it about 1/2 a dozen times because I don't want to cause undue wear on the pin and cause the match slide to be sloppy.
Has anyone had either of these issues? This is the first time I have bought a conversion for a witness and so much for just drop in and go.