-
Posts
175 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by mayassa
-
-
That is weird from customer support. I had 1 screw that was stripped on mine " maybe my fault" sent them a email and they sent a new holster in 3 days.
-
Holy crap you revived a really old post. I use clear shoe bins from Costco.
-
1.245 but I use berry’s hollow base bullets with STI GEN 1/2 and MBX mags no issues.
-
I haven't seen a detailed close up video on all the new features yet, but they are selling them. I will keep my 650 it runs perfectly now.
-
I roll sized a ton of 40 with the glock bulge.
-
I ordered mine today. I’m thinking I can rig it to my case feeder for 38 with a bigger plate for the ammo I loaded already.
-
I don't get why people are chasing pins, I separate mine in the media separator then strain them. This takes 2 minutes.
-
Thanks. I guess I'll find out tomorrow.
-
Does the rollsizer come with plastic hose? If not what size hose does it take?
-
3 hours ago, Laxman2809 said:
I know i can buy it new, and I plan to for my match ammo. However I would love a cheap/free source of once fired brass to train with.
I bought mine new, I mark mine and pick it up after shooting it.
-
54 minutes ago, Face5535 said:
“Brass is hard to come by”? That’s totally a subjective thought and one that I disagree with. I have 20k+ sitting on my bench.
Sent from my iPhone using TapatalkI thought I was set with 5 k sitting around.
-
-
I don't think its a big deal to use pins, all I do is use my media separator then dump the pins through a rice strainer then dump them back into my drum. Takes me an extra 2 minutes per batch. And this is a picture of the rice strainer on amazon with a few leftover pins in it.
-
Good lord what does this cost?
-
-
-
20 minutes ago, SterlingSomeone said:
Video link is down on my end. Anyone have another link? My vibraprime has been collecting dust and it sounds like it may be time to resurrect it.
Try it now
-
I went with drilling a hole at first too.
-
-
I am pretty sure you can but the swap the other portion of the dropper assembly for your toolheads.
-
You can gently bend the rod out at the bottom bend, but I would take it apart and clean it first to make sure nothing is binding.
-
-
Frankford Arsenal Vibra Prime Mod
I made this video to help out another guy on the forum, figured it could help out a lot of people. Happy New Years!
-
2 hours ago, Dirtchevy841 said:
how are you guys mounting the 1050. My reloading room with have 2 inch thick butcher block counter tops. Are y’all using plates on top and under counter top or just bolting to the counter. I was thinking of putting a metal plate under the counter and then screwing the press down. Or is a top pate needed also.
I bolted mine down to my bench no plates
Guga Ribas Ball Joint Holster Problem
in Gear & Accessories
Posted
I agree with this. I looked at mine and I have a small gap on each side and it's rock solid. Just sand off some material on each half.