catwrench

i would like to down the road , but for now i have case feeder and six caiber conversions .

thanks for the info , then i guess when the die closes the flare on case mouth in seating and taper crimp it doesn't stick or hang up ?

i didn't think about lead,as fori have been shooting jacketed. thanks food for thought.

thanks this helps alot.

got a question for you guys. would like to use station three on 550 for bullet feeder and i was wonder who makes a taper crimp seating die in carbide for 40/10mm 45acp and do you for see any issues.

what ever works to stop the primers is worth it.

just keep your dillon vib. tumbler . and do what i did got the thumbler tumbler on e bay cheap and purchased the stainless media from bufflo arms and you wouldn't belive how nice they turn out.talked to few guys on this forum and after that i spent the money and and now i wouldn't go back my cases have never been this clean .

thanks hope you don't mined but iam going to copycat you mod.thanks

thanks alot i printed it up and is now posted on my wall great pepole ,great forum ,lots of great info

thanks alot for the info,will do that i would have been po if i was ready to run a batch and think everything is ready and run into that problem.

thanks guys i will use that aproach and go from there.and see which loads work best for me. i'am sure some loads will be mor accuate then others provided i'am accuate shooting them.

guys do you have a step by step way you develop your test loads or do you work up 10 rnds. at min. and chrono or do you work up say 4 10rnd loads of different powders and chrono. ?

hi there your going to really like your new chrono, like they said in post above buy extra supports, my first outting was cut short do to shot side support in half.now i have plenty on hand and also a roll of duct tape.

Welcome California ,whats the temp. out there,here in Wisconsin we are at 75 .

Thanks so much very helpful group of guys.