Swapping from using the casefeeder to manual feed is as simple as removing the bin holder/cartridge chute from the strongmount (3 bolts),
remove 1 bolt from front right corner of press (enables the cam plate for case feeder to swing out of the way)
remove two small allen screws holding the case feed assembly from under the sub plate ( a bit tricky to get at but a ball end hex key makes it easier)
Install manual case feed plate (those 2 small hex screws)
Install bolt back into corner of press base (leaving cam plate swung to the rear)
and reinstall bin holder/cartridge chute
I can do this in under 10 minutes......and no realignment of subplate required
obviously going back to casefeeder is pretty much the reverse