Oddballmkg

What is the difference between the old 650 case feeders and the new one? I have about 120,000 rounds though my 650’s case feeder, and the electric motor no longer has enough torque on the low speed to feed case that are bigger than .223. If I use the high speed on the case feeder then I run into problems with the empty cases hanging up on the edge of the case feed mouth area (where the case fall down into funnel). I’m I better off buying a new case feeder or just replacing the electric motor?

I’m new to the forum but I’ve what did to fix the spent primer holder on my 650 was to make a lid out of duct tape then leaving a small channel where the primers fall into the tray. I also made a small wall around the opening with the tape, so that upper edge of the tape sets up against the lower surface of the spent primer tray. What I found was that the primers where actually bouncing out of the tray though the open top all over the floor. I did this on my 650 ten years ago and 98,000 rounds later, it’s worked perfectly.