Search the Community
Showing results for tags 'hiperfire 24c'.
-
I shot an indoor match this evening and my PCC decided to double on me, twice I have a little over 2000 rds of 132 PF ammo run through it. It doubled once on 24 rd stage 1 and then again on 32 rd stage 3. No problems on stage 2. Both times it doubled I was engaging a close target and really pushing the speed. It has a PSA Glock magazine lower with Hiperfire 24c trigger with the heavy springs (for the lightest trigger pull) and a CMMG ambi-safety. I installed KNS anti-walk/anti-rotate pins about 300 rds ago. The trigger pull did degrade slightly when I installed the pins. Inspection shows nothing unusual. No strange wear, cracks, chips or peening of the hammer or disconnector. Ideas on what is causing the doubling and more importantly, ideas on cures? Thanks. Bill
-
I have a Palmetto State Armory AR-9. I installed a Hiperfire 24C trigger in it that runs 100% and is absolutely wonderful. I am now trying to install an ambi-safety in place of the single sided OEM unit. I removed the grip, spring and safety selector detent. At this point I expected to be able to remove the OEM safety selector by just sliding it out. However, there is a rear extension on the 24C trigger assembly that is under spring pressure and rides atop the safety shaft between two shoulders. I cocked the trigger and moved this up and completely off the selector using a screwdriver blade. This appears to completely disengage the trigger assembly but I can only move the OEM selector about 3/32 out before it catches on something. No amount of spinning the selector has made a difference. I checked visually and can't see anything that is interfering with the safety shaft but maybe I'm missing something. I double checked the detent chamber to make sure there wasn't something else in there but it is clear. If there had been something, I shouldn't have been able to spin the selector 360-degrees. Am I doing something wrong? Do I need to remove the trigger assembly? If anyone else has installed an ambi-safety with a Hiperfire 24C, did you encounter a similar issue? Thanks in advance for your help.
- 7 replies
-
- hiperfire 24c
- ambi-safety
-
(and 2 more)
Tagged with: