Worked up to 9.8 grains which got me to where I wanted to be right around 172-173 power factor. The warm load was indoors at 70 degrees then kept in my truck with the heater on until ready to shoot. The cold load was kept outside in the bed of my truck for a couple hours until shot. The difference wasn't huge but could be a factor if you like to keep it close. After getting the load to where I wanted it I loaded 100 rounds and shot a few drills. Liking this powder so far. May have found my
Ok. I dont want to flood you guys with an ocean of data on all work up and how I got there. Unless you want to LOL. So here is the meat and potatoes. I am DONE LOL.
After very careful testing and load workups I can easily say that in order to Match LOT 514 Velocity, Lot 115 needs 0.5 Grain more powder and Lot 314 needs 1.0 Grain more.
Brass - New Rainier Arms
Primer - CCI400 SRP
Bullet - MG JHP 115 and 124gr
Chrono - Labradar (Velocity Data @ 10ft for Po