550 rest position

[kmca]

One of my 550's doesn't quite come to rest with the shell plate high enough to rotate. I've been looking at this thing and it's schematic diagram and I can't figure what makes the ram come to rest where it does. It's an older press and my others don't have that problem. What am I missing? Any ideas? Thought I'd check here, before I call DIllon.

[Guest]

Maybe replace the primer slide spring that is under the primer cup?

I replaced that spring on my old 550 and was suprised at how weak the old one had become.

[kmca]

Thanks for the reply. It made me look at the loader again and the spring on the powder drop was a little "loose". Tightened it up and it's fine