MickB Posted May 28, 2011 Share Posted May 28, 2011 All of my JP triggers are paired with JP speed hammers. If I take a GI rounded hammer and cut the tail off, would trigger pull quality be the same as if I used the JP hammer? Mick Link to comment Share on other sites More sharing options...
cardiackid Posted May 28, 2011 Share Posted May 28, 2011 It will quicken it up a bit, however the JP and other aftermarket triggers have a precision edge/finish on their contact surfaces on the hammer, disconnector, etc. and by using GI parts you're going to sacrifice that. In my original carbine I had a ground off hammer bob and the JP yellow spring set and it was a noticeable change from a stock GI/mil-spec trigger group but it in no way compares to a full aftermarket setup. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now