-
Posts
196 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by vernbo
-
-
I fixed a friends canik stovepipes with a kingglock 13 # guiderod with adapter cup , then the fireing pin spring was strong enough to sometimes hold out of battery causing light strikes , which i fixed with a glock fireing pin spring now he reports all good .
-
have you tried shooters connection?
-
yes, I use Wilson 45 mags in my 40 s&w & my 10 mm single stack guns . I don't even have any 40 mags.
-
checkout this thread
http://www.brianenos.com/forums/index.php?showtopic=46977#entry537645
my post number 10
-
I think they are chambered longer because , when loading to the high power factors in uspsa the long freebore lessens high pressure spikes .
-
bolt is 10-32 x 1 1/4
there is also bushing , bowed washer , nut , are they still there?
-
if you read this thread
http://www.brianenos.com/forums/index.php?showtopic=46977#entry537645
post-- number 10-- that is how i stopped the rounds from getting bellow the follower with sti mags .
-
check daa , kit for fitting grip to your hands.
Grip Customization Kit Overview and Instructions
-
fastshooter 03
i have one of your toolheads that i use for supercomp ,it has been a very good fix for the mis alinement on the resizing station.
-
-
should be an e-mail from practiscore with link to go back to squad list.
-
check list before leaving for matches.
bullets go in ,mags
mags go in , gun
gun goes in , holster
take all of those things with you.
-
did it get colder those last matches ? lube to thick !
-
rcbs trim pro with three way cutter. powered with cordless drill. not my video .but just like my setup.
-
how about one nut off of each link top or bottom ,left or right?
-
-
COM holsters , will make what you need.
-
don't remember all details ,but have read before about putting barrel in freezer ,brass shrinks faster than steel ,than find a tight bore brush that will grab the piece.
-
did you check if Jerry pawned the Steyr
-
`another trick for flathead screws . after you have melted loctite. use a very sharp pointed center punch and hammer on almost outside edge , leaning on a reverse direction and tap the screw out.
-
I load 40,s out to 1.200 and use wilson 45 mags. works fine.
-
if the top round is moving forward a fix , polishing the disconnector rail might stop round from moving ,it has worked for me.
-
you can also place gun in one or more heavy zip lock bags, heat holster then force into holster.
-
are these american made?
New to USPSA revolver—tips and resources for a newcomer?
in Revolver Forum
Posted
find a smith that can do this