Jkp1987

Thank you all

If I flip cases over they fit in over half way(pic below) So I "sharpied" A round that doesn't fit and one that does. (Pic below. Case on left doesn't fit). Hard to tell but there may be loss of ink at case mouth. the non fitting case measures .380 at mouth; .380 mid case; and .386 at base. the commercially processed case that fits measures .377 at mouth; .383 mid case; and .386 at base so I guess I should crimp more...

OAL is 1.142 and I measured all the cases from mouth to base at .747 +/- .002. I will send a pic this evening. Thank you for the input

Question for this knowledgeable forum... I am loading once fired 9mm brass on a Dillon 650XL (titegroup and berry 115g RN). When I resize and deprime the cases they fit my EGW 9mm 50 hole chamber checker easily. After I run the brass all the way through and have finished ammunition, more than half of them do not fit properly in the same chamber checker. Interestingly, the same rounds fit fine in a Dillon single case gauge. I am having the same issue with 308 I am loading on RCBS Rock Chucker. Any thoughts what I might have set up incorrectly? I appreciate the input! jkp

Question for this knowledgeable forum... I am loading once fired 9mm brass on a Dillon 650XL (titegroup and berry 115g RN). When I resize and deprime the cases they fit my EGW 9mm 50 hole chamber checker easily. After I run the brass all the way through and have finished ammunition, more than half of them do not fit properly in the same chamber checker. Interestingly, the same rounds fit fine in a Dillon single case gauge. I am having the same issue with 308 I am loading on RCBS Rock Chucker. Any thoughts what I might have set up incorrectly? I appreciate the input! jkp