[N320 40 S&W Load Recipes]

Thanks guys for your help!

 

 

[N320 40 S&W Load Recipes]

Unless I've overlooked it, it looks like all of the loads referenced here apply to the higher-end pistols. I used similar loads for my STI but have switched to a G35 for my backup for IDPA matches. That said, has anyone used either the N320 or N310 for .40?

Thanks

[Need recommendation for cylinder chamfering]

I'd like to make my S&W 686 able to accept moon clips. I need recommendations for gunsmith who can mill (?) the cylinder.

Thanks!

[Remington 1100 Tactical needs work]

I have a Remington 1100 Tactical I use for 3-gun. I need a good gunsmith who can modify or change out the lifter. Any suggestions would be appreciated.

[9mm Crimp Die adjustment needed?]

Correct-OAL is 1.155

[9mm Crimp Die adjustment needed?]

And my dies are the Dillon ones

 

[9mm Crimp Die adjustment needed?]

OAL is1.55"

Crimp is .385"

Bullet is MG 124 gr 

Barrel is Stormlake

 

[9mm Crimp Die adjustment needed?]

I load 9mm using my 550. I rarely get a perfect fit when I use a chamber gauge. I have a custom barrel in my G34 that I can't use because the rounds won't chamber/seat all the way. When I decap & resize, the brass drops perfectly into the chamber gauge. Since the bell of the brass is expanded by the powder funnel, and since I can see if the problem exists after seating the  bullet, I surmise the problem is with the crimp die. The reloaded rounds typically extrude at the base about 1/32" of an inch. They work fine in the factory barrel, but not the custom barrel. 

What do I need to do to get the reloads to work correctly?
Thanks!

Ken