1911builder
-
Posts
62 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by 1911builder
-
-
"This game is 90% about movement, 5% mental, 5% shooting"
-
check out mosin virus on youtube, he makes some guns for himself and documents them and shows you how to do the work. I would start there if I were you
-
another option would be to have a .40 gun built, then you can shoot major/minor depending on the day....
-
Everglades ammunition makes them, I saw them on their instagram page but not on their website. May have to send an email or give them a call.
-
I’ve ran them for over a year now. Absolutely love them, I️ wouldn’t hesitate to buy again, and have.... I️ get barely any smoke and coating doesn’t get in the comp and gum it all up.
-
I’m having some trouble with 2 if my 9mm 140’s
bullets get jammed side by side near the bottom of the magazine. I️ was told that I️ need to squeeze the magazine in a vise to close the tolerances.
Sti tubes with spacers
taran basepads
gram follow and spring.
Any any help would be appreciated.
-
I’m in California, no shot of a new frame here
-
Finally decided to pull the trigger on converting my old limited gun into an open steel gun for the fun of it. Ordered a couple new parts like slide, compensator, optic set up and we are now on our way.
I went ahead and ordered the ck slide and it is in spec. It is a tad loose on my old frame and debating whether or not to weld onto the rails to get a nice tight fit.
I will have to weld up the holes that are already in the frame from the thumb rest that was previously on the frame.
I will post pictures of my journey along the way as well as descriptions.
Plan:
Cut the slide down .5", lighten to get slide under 10oz by tri-topping, internal lightening cuts, and thru slide cuts. I will also have to add serrations since I won't be adding a racker this go around. -
Does anyone have a 9mm comp/alignment reamer that I could rent/borrow to align the comp that I set up? I don't really want to have to buy an $80 reamer for one gun
-
I love my viper, It wouldn't turn on once and I sent it back and got a new one within 7 days
-
Kydex mag pouch that i made mostly because It only cost me $15 for 7 pouches
-
Kydex holster with an aluminum holster that I made
-
I got one as a gift, threw it away immediately
-
Where do you send out your coatings to?
-
Am i the only one who doesn't run a slide racker? I also run a dpp so I have a lot of real estate on the back of the slide
-
I change my firing pin springs when I change my recoil/mainspring
-
titanium vs stainless comp? little bit more weight up front
-
I had a similar issue and sent it back. They replaced it free of charge and a two week turnaround time
-
Practice finding the dot through ports and awkward positions
-
poppet holes always make my glass smoky especially with major gas loads
-
I like the 124 since I have 10,000 of them
-
my vote is atlas, quick turnaround
-
I had to fit my magazine catch to the bodies of my magazines.
-
these are all beautiful guns
Aftermarket slide or machine work for RMR
in Glock
Posted
Best one that Ive dealt with so far is
cncholsters.com . Cleanest work that Ive come in contact with and a weekly turn around...oh yeah, and $85 for it