Merry Christmas Forum. This is my first post.
Need help reassembling the 1050 primer arm back into the slide.
I had to remove my 1050 primer magazine to clear a crushed primer. I now am unable to position the primer arm in the primer slide so that it does not either bind (when handle pulled down halfway) or disengage from the roll pin (when handle pushed upward). There is no rubber tube on my machines roll pin.
I have played endlessly with the bracket height +/- 4.6” above the press, and slightly different facing angles. I have tried positioning the arm into the slide at front, mid and far points of slide travel, unable to cure this problem. When the arm is positioned into the slide at either the front and mid points of slide travel, it will pop out when at the slide moves farthest from shell plate. Conversely, it will bind midway thru travel back when the height is positioned in the slide farthest from the shell plate. Additional notes, I can move the slide freely when its not engaged to the arm, so there does not appear to be any debris obstructing it movement. I have loaded 2k with no problems prior. Please share advice on how I can get this back together and reloading again.
Thanks!