hi all!!! im pretty new to this site and was hoping a gunsmith or a fellow forum guy would help me out...i own a classic p14 45 and after doing a trigger job on it by some gunsmith here in the philippines, the hammer falls to cocked position after releasing the slide stop from open chamber with or without an empty mag on it....also it will fall to cocked position when you pull and release the slide faster than normal.....from what i know the gunsmith stoned the hammer and sear and adjusted the sear spring....installed a new ed brown trigger....so i presumed the fault is caused by one of which. So i consulted another gunsmith and he convinced me to buy another set of hammer and sear.....so i did...and had him installed it...i went home and still the same problem....hammer falls on cocked position when slide stop is released from open chamber with and without an empty magazine....well both gunsmiths did not use any sort of magnifying glass to check on the hammer and sear engagement...but claimed that it engaged well....now im really puzzled ...is it the hammer and sear engagement? is it the disconnector? the triger? a combo of all? any help guys would be deeply appreciated thanks!!