jduvel
-
Posts
7 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by jduvel
-
-
If you haven't already polish all your contact points and it should be ready to run.
-
19 hours ago, Don_B said:
The best way I found to bevel the pin is to put it in a drill press and use a file to bevel it then use some fine emery cloth or a stone to polish it smooth.
Well, so far so good. I ran 600 rds last night with no issues. Thanks for the help!
-
On 4/29/2018 at 12:16 PM, RickT said:
Is your sizing die adjusted correctly? Is the primer just being partially pushed out? And the C-clip is still intact? I no longer use my Dillon sizer, but in general it's possible for the pin to partially re-seat the primer on the upstroke if the primer sticks to the pin. I don't recall this happening with the Dillon die. BTW, I only load 9mm.
I think the primer is sticking to the pin and getting pulled back into the pocket. I'm going to mess around with the pin tonight. Thank you!
-
On 4/29/2018 at 1:00 PM, V2plus25 said:
Is the Mighty Armory one a sizing die as well? When I looked it appeared it was not.
Dillon swears their new sizing die has a spring in it that is supposed to prevent the primer from sticking on the pin. I was also having this problem and chose to go with the Lee sizing/decapping die. 8600 rounds on it so far and no stuck primers. The Dillon decapping pin must have a peculiar shape to it that in my experience tends to have CCI primers stick on it.
Decapping only. Have to have a sizing die in station two
-
When decapping with Dillon decapping die I'm having issues with primers not being pushed out. Mainly Blazer brass that I see the issue with. This is a new machine with maybe 500 rounds through. Made sure pin was tight. Anyone else seen this issue?
-
147gn Blue bullet over 3.2gn titegroup getting 130PF
Shadow SP01 Frame
in CZ
Posted
I have a spare shadow slide that I've had laying around and was wondering if there was a place to buy a replacement frame?