Aggie
-
Posts
54 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by Aggie
-
-
-
18 hours ago, chase214 said:
I have the apex kit in my M&P and all I use is small rifle primers and haven't had a problem yet
Good to know...thanks.
-
Anyone know if the apex flatty kit will set off small rifle primers?
-
Any updates on when these will land in the US?
-
Salomon speedcross 4 is ok now that wide sizes are available.
-
The amount of time spent tinkering with all of the adjustments is a bit of a headache.
-
Sturdy holsters but the couple I've had needed a heat gun and dremel to get them where I prefer.
-
Anyone using clays for a 9 minor load in uspsa?
-
I also have this issue from time to time. It also seems like the deeper I try to seat primers the more likely the bolt holding the rocker arm to the press will begin to back out. The result is partially seated primers and a little disassembly/reassembly.
-
They are DA/SA
-
USPSA on Facebook says now legal for carry optics...they probably meant production since guns have to be on production gun approved list for carry optics.
Sent from my iPhone using Tapatalk -
Thanks for the update.
-
On 8/8/2016 at 4:41 AM, Less said:
Less, any updates you could share on the progress of this sight? Thanks
-
I have to Stock 2s and one is flush and on the other the slide sticks out considerably more than yours does. Both perform flawlessly. Cosmetic anomalies are common with these guns. Shoot and enjoy!
-
I like the DAA, but any one of the belts recommended will get the job done. I used to run the Ghost pouches but they were a bit bulky so I now use RLN Custom adjustable sidewinder pouches. They're kydex and don't dig into your side at all like the Ghost pouches can do. That's more of a girth issue, though.
-
11 minutes ago, MemphisMechanic said:
Did you shoot or handle a Stock 3 as well, before choosing the 2?
I handled one but never considered getting anything other than the 2.
-
I chose a Stock 2 because I liked the looks and balance of it better than the Stock 3. The cone barrel was also a selling point for me.
-
Almost recommended some duct tape lol.
Sent from my iPhone using Tapatalk -
That leg on the spring should tuck back into crevice the spring sits in. Not sure how to explain it any better.
-
I shot a used Stock II at nationals without concern. These guns are solid.
-
It's pretty useless, I'm not even on there. lol
-
I tried 3.0 grains with coated bullets. Worked fine.
-
johnbu, even when we could get off roster guns the pricing was outrageous. The laws for buying guns are going to get worse.
-
Someone is always willing buy used grips on this forum.
Extended Basepad Compatibility
in Canik
Posted
Anyone know if the Taylor Freelance extended basepads for the PDP will work with the Canik SFX Rival? Thanks