Keydet08
-
Posts
13 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by Keydet08
-
-
I’m have the swage on order. If it is anything like their decapper I won’t be disappointed.
-
I’m not sure where you are looking but at the prices I have seen the round bar is 4.5 times more expensive than equivalent nominal diameter rebar. For 60 feet it’s $100 vs $450. I’m going to use the cheapest viable option.
-
Working on building metal bases for 3/4 PVC walls. Basically going to be a cross of 1.25 inch x 1/8 inch steel strip with a piece of rebar for the vertical to fit into the PVC. The inside diameter of schedule 40 3/4 PVC is 0.824in. I don’t know if I should get #5 or #6 rebar. The nominal diameters of the rebar are 5/8 and 3/4 but I don’t know and can’t seem to find the actual outside measurements of the rebar. Does anyone know the actual outside dimensions or have any experience with this?
-
I had a similar problem recently. The half circle shaped retainer that keeps the primer shuttle in was not fully tightened down. It caused the primer shuttle to go a little too far back and not pick up the next primer correctly.
-
3.0 gr Titegroup 1.14 OAL 132pf in G34
-
1050
If you stay in the game long enough you will end up going to it.
If you get a different machine you will wish you got the 1050.
It's not that complicated.
-
echotango, thanks I'll try that load
-
Looking for any experience with this combination. It will be loaded in a 9mm 2011. Looking for about 130pf.
-
147gr RN Blue Bullet
3.0gr Titegroup
1.14 OAL
132 PF out of G34
-
I got the frankford arsenal dryer to go with the wet tumbler. I run the dryer at the highest heat setting, about 158 degrees, and let it dry for the three hours the next batch is in the tumbler. It works very well.
-
When I have 147gr xtremes I load them with 3.0gr of titegroup at 1.14 OAL. Comes out right around 125 PF in a stock G34.
-
Does anyone know if the TTI base pads are compatible with the carver magwell? Thanks...
Stand alone mount for Mr Bullet Feeder found!
in non-Dillon Reloading Equipment
Posted
The range panda mount is the way to go. Anything to isolate it from the shaking of the casefeeder or press.