Keydet08

The range panda mount is the way to go. Anything to isolate it from the shaking of the casefeeder or press.

I’m have the swage on order. If it is anything like their decapper I won’t be disappointed.

I’m not sure where you are looking but at the prices I have seen the round bar is 4.5 times more expensive than equivalent nominal diameter rebar. For 60 feet it’s $100 vs $450. I’m going to use the cheapest viable option.

Working on building metal bases for 3/4 PVC walls. Basically going to be a cross of 1.25 inch x 1/8 inch steel strip with a piece of rebar for the vertical to fit into the PVC. The inside diameter of schedule 40 3/4 PVC is 0.824in. I don’t know if I should get #5 or #6 rebar. The nominal diameters of the rebar are 5/8 and 3/4 but I don’t know and can’t seem to find the actual outside measurements of the rebar. Does anyone know the actual outside dimensions or have any experience with this?

I had a similar problem recently. The half circle shaped retainer that keeps the primer shuttle in was not fully tightened down. It caused the primer shuttle to go a little too far back and not pick up the next primer correctly.

3.0 gr Titegroup 1.14 OAL 132pf in G34

1050 If you stay in the game long enough you will end up going to it. If you get a different machine you will wish you got the 1050. It's not that complicated.

echotango, thanks I'll try that load

Looking for any experience with this combination. It will be loaded in a 9mm 2011. Looking for about 130pf.

147gr RN Blue Bullet 3.0gr Titegroup 1.14 OAL 132 PF out of G34

I got the frankford arsenal dryer to go with the wet tumbler. I run the dryer at the highest heat setting, about 158 degrees, and let it dry for the three hours the next batch is in the tumbler. It works very well.

When I have 147gr xtremes I load them with 3.0gr of titegroup at 1.14 OAL. Comes out right around 125 PF in a stock G34.

Does anyone know if the TTI base pads are compatible with the carver magwell? Thanks...